Kiss "keep It Simple Stup**" Aug 12, 2016

OK, first thing to do is to consider the space, (including walls and doors) you are trying to condition. Envision the air flow between where the air will eventually come in and where it will be exhausted once you install the ductwork. Lastly, based on the inlet and exhaust locations, figure out where you want to position the unit you are going to use. Now there are lot's of installation tips an experienced professional can offer you while going through this process, but common sense and a... more

Works Well But Price Has Gone Up Jun 20, 2016

I have had this Panasonic Dual Zone CU-2E18/CS-E12x2 for over 2 years now. I am pleased overall but would offer a few tips: - My application is primarily for heating, and I am in a location where temps can dip below zero. The unit does a surprising job of heating down to 5 degrees F, but after that will drop off significantly, and eventually shut itself off around zero. As a result, you really want to have a backup source of heat in that climate. (I used cheap electric strip heaters) -... more

Goodman Gsx13 - 4 Ton - Air Conditioner Mar 30, 2016

Very quiet, you can only hear the fan running. Suction line service valve is too close to the case makes it difficult to braze the suction line in.

New Heater Installed May 30, 2016

The heater was ordered on a Friday and I could have gotten it on Wed but I could not have anybody here to receive it till Friday. It arrived on Friday morning just as I finished taking out the old furnace. I had it up and running by Monday, I tried to get the new one as close as possible as the old one in output and so I only got the single stage. I could not find the size as to how wide, deep, or height but that was probably my fault but it worked out great the only difference was the height... more

Pleased With Purchase Nov 03, 2016

I bought the furnace, evaporator coil with TXV and condenser. I was pleased with the way everything came packaged for shipping. Each piece seems to be built well so the installation went together quite well. The only thing I did not like was getting the TXV installed as there was not enough space to get the fitting through the wall of the evaporator housing.